My thermostat is set to heat, but my heat pump isn't coming on. Why?

If your thermostat is newly installed and the heat pump worked with the previous thermostat, check the following:

1. Verify that the thermostat is set to heat and is calling for heat, usually indicated by the words “heat on," a flame icon, or a shimmering sun icon. If the room temperature is below the heat set point, the thermostat display should indicate a call for heat.
2. Confirm that the circuit breakers are on.
3. If you installed the thermostat yourself, ensure that the wires are matched correctly and securely connected at the thermostat.
4. If you installed the thermostat yourself, verify that the thermostat is correctly configured to control a heat pump. The installation instructions for your thermostat show these settings.
5. If the heat pump runs in cool mode with a call for heat, verify that the configuration setting for the changeover is set correctly for your system. The configuration settings are shown in the installation guide for your thermostat. If you do not know whether your heat pump uses the changeover valve in heat or cool mode, call your professional HVAC contractor or the manufacturer of your heat pump.
6. If there are not separate wire connections to R and Rc on the thermostat, those terminals need a jumper. Some models use a small metal jumper and other models have a switch that needs to be set to "R".

If the same issue occurred with the previous thermostat, then the problem is most likely with your heat pump. Call a professional HVAC contractor if the above steps don't solve the issue.
Last updated: July 06, 2018
Was this article helpful?



Tweet Us

Follow us for the latest news on Honeywell Home.
7 AM – 7 PM CST,
7 days a week.

Live Chat

Live Chat

8 AM to 10 PM CST,
7 days a week.

Send Mail

Email Us

Don’t need urgent assistance? We’ll get back to you within 48 hours.

Call Us

Call Us

Experts are ready to help Monday to Sunday.